|      |       |   

📋 Quick Start (3 steps)

  1. Plug the USB dongle into your computer and turn on the white remote (sensor puck).
  2. Click Connect below → in the popup, pick the IOLab device.
  3. Click Start to record, Stop when done, then Save to download your data as a CSV.
💡 Confused by your graph? Tap the 🤖 Ask AI button (bottom-right) → Load my captured data, then just ask it to fit a line, smooth the noise, or explain what your data means — right here, no file uploads.

Timer

            Save:     Restore:

   Cal:   DAC:   D6:   Bzz:   D4:   D5:
  
Tx: Rx:

Calibration Control ×

Options and Preferences ×


Select which sensors to reverse the y-axis for:
Accelerometer   
Force   
Gyroscole   
Magnetometer   
Wheel   
Select which output controls to display when your remote is on:
DAC (analog)   
D6 (digital)   
Buzzer   
D4 (PWM)   
D5 (PWM)   
Specify the vertical component of the Earth's magnetic field at your location to improve your magnetometer calibration:
Local Bz = uT   (Look here for detailed instructions)
Specify how long to let your IOLab be idle before powering it down to save power:
Inactivity Timeout   


Pairing Dialog ×

To pair the Dongle with a Remote, put the remote into Discovery Mode
and click the PAIR button at the bottom of this dialog.

To put your remote into Discovery Mode:
1. Make sure it is turned off.
2. Hold down the + button while you turn the device back on.
3. Keep holding the + button for about 3 seconds until the lights flash as shown below:

(If you are unsure, this video shows you how to do it).